IEC 60068-2-32 Procedure 1 Free Fall Test Machine For Impact Resistance For Packaging Falling

IEC 60068-2-32 Procedure 1 Free Fall Test Machine For Impact Resistance For Packaging Falling

Product information:

Standard: IEC 60335-1 Annex B, IEC 60068-2-32 procedure 1, ISTA, GBT 21599-208, ISO2248, JISZ0202-87, GB/T4857.5-92, etc.

This machine is specially used to test the damage of product packaging caused by falling, and to evaluate the impact resistance during transportation and handling. It can perform free drop tests on the surfaces, corners and edges of packages, and is equipped with a digital height display and a decoder for height tracking. As a result, the drop height of the product can be accurately given, and the error from the preset drop height will not exceed 2% or 10mm.

This machine adopts a single-column structure and has electric reset, electronically controlled drop and electric lifting devices, making it easy to use. The drop height is accurate, the display is intuitive, the drop arm rises and falls smoothly, and the drop angle error is small.

Technical Parameters:

1. Model: Detachable

2. Drop height: 300-1500mm, adjustable

3. Maximum weight measured: 0-65kg

4. Maximum size of test piece: 800 × 800 × 800mm

5. Impact panel size: 1700 × 1200 × 25 (solid iron plate, thickness 25mm)

6. Support arm size: 160 × 180 × 8mm

7. Drop error: <2°

8. Drop height error: ±10mm

9. Control box size: 370 × 350 × 910mm

10. Overall dimensions of the test bench: approximately 1700 × 1200 × 2300mm

11. Equipment weight: about 550kg

12. Power supply: AC220V 50HZ (please confirm the power supply used on site. If you need to change to other voltages, please note the quotation in advance)

13. Power: 1.5KW

Environmental requirements:

1. On-site temperature: 5℃~+28℃ (average temperature within 24 hours ≤28℃);

2. Relative humidity: ≤85%RH;

3. Power supply conditions: single-phase three-wire;

4. Voltage range: AC220V;

5. Allowable frequency fluctuation range: (50±0.5) Hz;

6. The grounding resistance of the protective ground wire is less than 4Ω;

7. The user is required to configure an air or power switch of corresponding capacity for the equipment at the installation site, and this switch must be independent for use by the equipment.