|
| एमओक्यू: | 1 |
| कीमत: | विनिमय योग्य |
| स्टैंडर्ड पैकेजिंग: | Aluminium Box |
| प्रसव अवधि: | 3 Days |
| भुगतान विधि: | T/T |
| आपूर्ति क्षमता: | 100 sets per month |
IEC 60745-2-5 Figure 110 Probe B" With 12mm Diameter 50mm Length For Circular Saws Test
Product Overview:
Standard: IEC 60745-2-5 : Particular requirements for circular saws, clause 19.101.2.4 and Figure 110
Application: This probe is applicable to checking the accessibility of the cutting edge zone at the saw above the guide plate.
Test sample: Circular saws
For checking the accessibility of the cutting edge zone at the front of the saw above the guide plate, the rigid test probe ‘b’ of Figure 110 shall not contact the blade when the saw is set for a 90° cut and any depth of cut and the probe ‘b’ is centred with the blade then advanced in any single plane perpendicular to the blade and parallel to the guide plate, as specified in Figure 111. The test is repeated with probe ‘b’ offset 13 mm to the right of the blade centre and then offset 13 mm to the left of the blade centre.Compliance is checked by inspection and measurements.
Technical Specifications:
| Probe length | 50mm |
| Probe diameter | 12mm |
| Probe material | Stainless steel |
वीडियो
वीडियो
वीडियो
वीडियो
वीडियो
वीडियो
|
|
| एमओक्यू: | 1 |
| कीमत: | विनिमय योग्य |
| स्टैंडर्ड पैकेजिंग: | Aluminium Box |
| प्रसव अवधि: | 3 Days |
| भुगतान विधि: | T/T |
| आपूर्ति क्षमता: | 100 sets per month |
IEC 60745-2-5 Figure 110 Probe B" With 12mm Diameter 50mm Length For Circular Saws Test
Product Overview:
Standard: IEC 60745-2-5 : Particular requirements for circular saws, clause 19.101.2.4 and Figure 110
Application: This probe is applicable to checking the accessibility of the cutting edge zone at the saw above the guide plate.
Test sample: Circular saws
For checking the accessibility of the cutting edge zone at the front of the saw above the guide plate, the rigid test probe ‘b’ of Figure 110 shall not contact the blade when the saw is set for a 90° cut and any depth of cut and the probe ‘b’ is centred with the blade then advanced in any single plane perpendicular to the blade and parallel to the guide plate, as specified in Figure 111. The test is repeated with probe ‘b’ offset 13 mm to the right of the blade centre and then offset 13 mm to the left of the blade centre.Compliance is checked by inspection and measurements.
Technical Specifications:
| Probe length | 50mm |
| Probe diameter | 12mm |
| Probe material | Stainless steel |
